The aliasing problem
In principle, a Nyquist frequency just larger than the signal bandwidth is sufficient to allow perfect reconstruction of the signal from the samples. However, this reconstruction requires an ideal filter that passes some frequencies unchanged while suppressing all others completely (commonly called a brickwall filter). Such a filter is both unattainable in practice and, even in theory, introduces unwanted time domain artifacts such as ringing artifacts.
Signal frequencies higher than the Nyquist frequency will encounter a “folding” about the Nyquist frequency, back into lower frequencies. For example, if the sample rate is 20 kHz, the Nyquist frequency is 10 kHz, and an 11 kHz signal will fold, or alias, to 9 kHz. However, a 9 kHz signal can also fold up to 11 kHz in that case if the reconstruction filter is not adequate. Both types of aliasing can be important.
When attainable filters are used, some degree of oversampling is necessary to accommodate the practical constraints on anti-aliasing filters: instead of a brickwall, one has flat response in the passband up to a point called the cutoff frequency or corner frequency, (pass all frequencies below there unchanged), then gradual rolloff in a transition band, finally suppressing signals above a certain point completely or almost completely in the stopband. Thus, frequencies close to the Nyquist frequency may be distorted in the sampling and reconstruction process, so the bandwidth should be kept below the Nyquist frequency by some margin (frequency headroom) that depends on the actual filters used.
For example, audio CDs have a sampling frequency of 44100 Hz. The Nyquist frequency is therefore 22050 Hz, which is an upper bound on the highest frequency the data can unambiguously represent. If the chosen anti-aliasing filter (a low-pass filter in this case) has a transition band of 2000 Hz, then the cut-off frequency should be no higher than 20050 Hz to yield a signal with negligible power at frequencies of 22050 Hz and greater.
To avoid aliasing, the Nyquist frequency must be strictly greater than the maximum frequency component within the signal. If the signal contains a frequency component at precisely the Nyquist frequency then the corresponding component of the sample values cannot have sufficient information to reconstruct the Nyquist component in the continuous-time signal because of phase ambiguity. In such a case, there would be an infinite number of possible and different sinusoids (of varying amplitude and phase) of the Nyquist frequency component that are represented by the discrete samples: see Sampling theorem: Critical frequency.
Other meanings
Early uses of the term Nyquist Frequency, such as those cited above, are all consistent with the definition presented in this article. Some later publications, including some respectable textbooks, call the signal bandwidth or twice the signal bandwidth the Nyquist frequency; still others refer to the Nyquist rate (twice the signal bandwidth) as Nyquist frequency; these are distinctly minority usages.
References
^ Ulf. Grenander (1959). Probability and Statistics: The Harald Cramr Volume. Wiley. http://books.google.com/books?id=UPc0AAAAMAAJ&q=%22nyquist+frequency%22+date:0-1965&dq=%22nyquist+frequency%22+date:0-1965&as_brr=0&ei=R0LsRtqLN6HApgLT8726Dw&pgis=1. “The Nyquist frequency is that frequency whose period is two sampling intervals.”
^ Harry L. Stiltz (1961). Aerospace Telemetry. Prentice-Hall. http://books.google.com/books?id=cro8AAAAIAAJ&q=%22nyquist+frequency%22+date:0-1965&dq=%22nyquist+frequency%22+date:0-1965&as_brr=0&ei=R0LsRtqLN6HApgLT8726Dw&pgis=1. “the existence of power in the continuous signal spectrum at frequencies higher than the Nyquist frequency is the cause of aliasing error”
^ B. V. Korvin-Kroukovsky (1961). Theory of Seakeeping. Society of Naval Architects and Marine Engineers. http://books.google.com/books?id=W7Q8AAAAIAAJ&q=%22nyquist+frequency%22+date:0-1965&dq=%22nyquist+frequency%22+date:0-1965&as_brr=0&ei=R0LsRtqLN6HApgLT8726Dw&pgis=1. “The Nyquist frequency is often called the folding frequency or cut-off frequency”
^ Michael J. Roberts (2004). Signals and Systems: Analysis Using Transform Methods and MATLAB. McGraw-Hill Professional. ISBN 0072499427. http://books.google.com/books?id=c2oN_GozNPoC&pg=PA503&dq=highest-frequency-present-in-a-signal+nyquist-frequency&lr=&as_brr=0&ei=aNGWR5vPN56ktgON2_jnBA&sig=c2t2D_p_8eYTSpQh_AkV1FG1hLo#PPA503,M1.
^ Uwe Windhorst and Hkan Johansson (1999). Modern Techniques in Neuroscience Research. Springer. ISBN 3540644601. http://books.google.com/books?id=cjCnNtIhjMQC&pg=PA630&dq=bandwidth+nyquist-frequency&lr=&as_brr=0&ei=8c6WR6G1LqLstAOsqPjnBA&sig=vVqDAkDdIdrcoirjCWZdPTIOpHQ.
^ Jonathan M. Blackledge (2003). Digital Signal Processing: Mathematical and Computational Methods, Software Development and Applications. Horwood Publishing. ISBN 1898563489. http://books.google.com/books?id=G_2Zh7ldQIIC&pg=PA93&dq=intitle:digital+intitle:signal+intitle:processing+nyquist-frequency&lr=&as_brr=0&ei=EsiWR8GAIYOUtgO865HoBA&sig=0nPyEIzaULnMF_UsY6TjPI6SN6w.
^ Paulo Sergio Ramirez Diniz, Eduardo A. B. Da Silva, Sergio L. Netto (2002). Digital Signal Processing: System Analysis and Design. Cambridge University Press. ISBN 0521781752. http://books.google.com/books?id=L9ENNEPbZ8IC&pg=PA24&dq=intitle:digital+intitle:signal+intitle:processing+bandwidth+nyquist-frequency&lr=&as_brr=0&ei=8MmWR8DJF6CQtwOu4_znBA&sig=JFC3km12VpmWY6RyusmB594ZTQQ.
See also
Nyquist rate
Kell factor
Sampling frequency
Superoscillation
Signal
Categories: Digital signal processing
I am an expert from medical-cushion.com, while we provides the quality product, such as medical seat cushions , medical wedge pillow Manufacturer, ,and more.